nav[aria-label="Primary Navigation"] { padding: 0; & ul { list-style: none; width: 100%; display: flex; flex-direction: row; justify-content: start; align-items: start; gap: 30px; padding: 0; & li { margin: 0; } & ul li { list-style: none; } } }

cannot authenticate or get DHCP address

unknown

New to Ruckus. Want to simply thorw a static IP on ruckus ap. Have Ruckus AP give out DHCP to clients on single wireless network. Route traffic through Ethernet 2 to firewall.

Internet - assigned static ip w/ gateway IP as firewall
Local Subnet 1 - assigned static ip (same subnet as Internet) and enabled DHCP server Access VLAN 1
Radio 2G - configured Wireless. Packet Forward - Bridge to WAN
Ethernet Port2 - Enabled Access Port, Bridge to WAN Vlan1

Can someone please point me in the right direction as to what I am doing wrong. I cannot get the Wireless to provide a DHCP address -

I can also give out DHCP addresses from Firewall. If I do that do I only need to configure Radio and Ethernet Port 2?

Thank you in advance

SJMP

Find more posts tagged with

Accepted answers

All comments

unknown

scopa.

this simple to do and below part is WRONG:

Radio 2G - configured Wireless. Packet Forward - Bridge to WAN

unknown

What should it be? If wrong.

unknown

scopa, you beat me in speed, i was in the process of coming up with an response for that step by step...

take a look at below URL - this allows you to set a static IP...

http://pasteboard.co/yYsuZgR.png

i am sure that was done...

unknown

Yes - already have a static on the device for Internet. Do I need to configure Local Subnet? And if so - change the packet forward to Local Subnet NAT and Route to WAN? Is WAN the the gateway configured on "Internet" page?

Thanks,

unknown

then when you create a local Subnet in the same pool as firewall/gateway subnet. Did you mention about no of DHCP users?

As i did in the screenshot on URL - http://pasteboard.co/yYIn6mW.png

unknown

if your gw/fw is configured to give away DHCP IP and if you create packet forward - bridge to WAN. this should do the trick...

unknown

First off - Thank you for the quick replies - appreciate the help.

Let me just review:

"Ethernet Port" 2 Enabled as Access Point / Bridge to WAN
"Internet" static IP w/ GW pointing to Firewall
"Local Subnet" Enabled w/ static IP (same subnet as Internet) & DHCP configured
"Radio 2.4G" Enabled "Bridge to WAN"

Does all of this look correct? Or should I change the packet Forward under "Radio"?

Thanks again

unknown

Still does not give out an IP address. Goes to Authenticating, then for a second "obtaining ip address" then back to Authenticating. Definitely using correct Password.

unknown

also see SSID island-02FFB0 pop up - assume there is an error somewhere?

unknown

"Ethernet Port" 2 Enabled as Access Point / Bridge to WAN --> ideally - settings on Configure :: Ethernet Ports
better left default...
"Internet" static IP w/ GW pointing to Firewall ---> this is ok
"Local Subnet" Enabled w/ static IP (same subnet as Internet) & DHCP configured.. --> this is ok
"Radio 2.4G" Enabled "Bridge to WAN" --> Here packet forward = local subnet NAT and route to WAN. once you set this option, another drop down will show up to select the local subnet you created...

this should be it...apply this and give it a run...

unknown

can u pls try this KBA -->

https://support.ruckuswireless.com/answers/000001423

unknown

also for testing...just give a static ip on the testing device. this static IP shall be from local subnet pool...give it a shot...