I can't run speedflex on the AP that is connecting to the controller .

Question

I can't run speedflex on the AP that is connecting to the controller . got an error that AP not have speedflex running or is behind NAT , any idea

sanjay_kumar · Answer

Hi Hayder,I'm not sure if this works when the AP is behind the NAT, as per some old cases. However, you can try checking the Firewall policy which I mentioned earlier.

hayder_al_windi · Answer

Thank you Sanjayyes the AP behind NAT environment

sanjay_kumar · Answer

Hi Hayder,Is the AP behind the NAT environment before reaching the Controller?If not, is there a Firewall between the AP and the controller?Port 18301 is used between the AP and the controller, make sure to allow it (Both TCP and UDP).The rule should be as below:Traffic from Controller to AP, source port ANY, destination port 18301Traffic from AP to Controller, source port 18301, destination ANY