Default super password after factory reset for unleashed configuration

Question

What is username/password afrer factory reset . Super/sp-admin does not work for unleashed firmware

JacksonCampbell · Answer

Unleashed also can be accessed and setup via 192.168.0.1. If default credentials aren't working for a ZoneFlex AP then it should be checked if there were previous credentials cached for the IP address (https://support.ruckuswireless.com/articles/000001909).

michael_brado · Answer

Repeating from another thread:
Unleashed initial configuration needs to be done using the APs default SSID, then browsing 
to https://unleashed.ruckuswireless.com when you'll be prompted to create the network and 
define your Admin credentials.  Setup is described in this knowledge base article for your 
 assistance:
https://support.ruckuswireless.com/answers/000005204

If you don't see a Configure.Me-XXYYZZ ssid in the air after factory defaulting your AP, 
I suspect that they are not running Unleashed code.  Then you need the direct AP to PC(pre-configured with 192.168.0.x ) so you can access https://192.168.0.1 (super/sp-admin)and upgrade to your AP model Unleashed code.I just posted a new Unleashed 200.6.10.1.308 btw...

unknown · Answer

try super as lowercase