When dealing with a corrupted flash or related issues, follow these steps to troubleshoot and resolve the problem.
Boot Loop Process
When a unit is stuck in a boot loop and fails to stabilize, the first step is to console into the unit directly and r...
This is a brief demonstration of how to use Unleashed tools to troubleshoot a basic connectivity issue on the network on end devices.
1. Client Connection Troubleshooting
Link as reference https://docs.commscope.com/bundle/unleashed-200.16-troublshoo...
This provides a concise summary of the Unleashed network's operation, outlining essential requirements and handy commands for configuration.
Unleashed Overview
In an Unleashed network, a RUCKUS Unleashed 'Master' Access Point acts similarly to a cont...
Overview of Port Mirroring and Monitoring
Port mirroring is an effective network traffic monitoring technique. It involves duplicating each packet entering or leaving a specific port on a network switch and sending this copy to another port for analy...
STP Protect is designed to enhance network stability by causing a port to drop STP BPDUs originating from the device connected at the other end of the link. The primary function of this STP protection is to prevent end stations from either initiating...
Hello Richard_NZ ,
You could try manually setting the PoE for the access points to the maximum power that the switch can provide to ensure compatibility.
Video Link : https://www.youtube.com/watch?v=hnpSEut96iw
check the Below link :
AP Power Warni...
Hello nakano978 ,
Hope you are doing well ,
If I understand correctly, you are encountering a grayed-out button when attempting to upgrade via the web UI. I recommend using a Firefox web browser and trying again.
You can jump from 200.7 to the laste...
Hello kasonde
To know the status of https and http are get https and get http
Here are the commands to run in a Master Access Points
ruckus> enableruckus# ap-modeYou have all rights in this mode.
ruckus(ap-mode)# get httpsHTTPs access is enabledBut...
Hello DoktorMac ,
Hope you are doing well ,
One of the requirements for adding Unleashed access points to an existing network is that they must be on the same firmware version. However, the R310 access points, having been discontinued for some tim...
This process should happen automatically, as both APs are part of the same network. For instance, if you're connected to AP1 and then move closer to AP2, you will likely roam to AP2 seamlessly, provided both APs are online and visible on the dashboar...
