Hi, I am having some problems configuring an icx8200 switch. I am following the Ruckus Fastiron Web Manamgement Interface UserGuid 10.0.10. The management port is assigned with an IP address, users ...
Hi all, I am a newbie to Ruckus equipment and even more specifically Fastiron 10. We have some 8200 switches in which they are functioning correctly, but I am unable to ping/ssh them. We are i...
Hi, I have two switches, ICX7450 and ICX7550. Below is a table with switch models and tested image SW versions. On both switches, I could not get Digital Optical Monitoring to work on Ruckus v...
Hello Ruckus Pack, I have four 7450 Switches with two 1Port 40Gig Modules installed in the rear slots. I want to build a stack with all 4 Switches. But when I stack connect them (via 0.5m QSFP+ p...
In cisco, the configuration is displayed such that interface is displayed first and vlan tagging or untagging is secondary. Is there a command in ruckus so that I check the vlan tagging based on por...
I have a 7150 that lost its config likely due to being reset. While I was replacing the config I pressed the status button and the switch started a factory reset. I have been unable to find how to ch...
...ater in this section, the instructor defines all the stack ports and trunks for all switches in the stack before enabling the stack and beginning the interactive-setup utility. What am I missing?
Hi, I recently purchased 4 ICX 7450 switches. The make is by Brocade not Ruckus. Is it possible to use the current stable firmware with these switches. I read that it is supported, but I am g...
I am currently running firmware version SPS08090g on my ICX7150-C12P. I feel like this firmware version is pretty out of date and was looking online which is the best to upgrade to ...
Hello, We have three ICX7150-48P SW Running Image Version:08.0.90dT211. Can you tell me what version is recommended, and can it be updated directly to the latest version, or are there some required ...