The following RUCKUS SmartZone 6.1.2 product guides have been published on the RUCKUS Support Portal.The PM can share the links below as needed for release announcements. SmartZone 6.1.2 (LT-GD) Public API Reference Guide (ICX Management)SmartZone 6....
Following quick set up talks about the SZ 144-D config but does not explain how the NIC's need to connect?https://ruckus-support.s3.amazonaws.com/private/documents/3409/SZ144-D-QuickSetupGuide-800-72550-001...Just mentions to connect Port 1 or 2 to t...
Hi, I have SmartZone with 490 APs, I need to set static IP addresses, at the moment APs are operating via IP from DHCP. Is there any possibility to configure each AP via SZ's cli, like I did in ZD's case?I need a script example, please advise
Hi all!I'm configuring Hotspot and having the following problem (figure)Does anyone know how to fix this problem?Thanks in advance!
I am installing a new setup of Vzs, with fw 3.6.2.0.222 in Exsi 6.5.0 , i use this firmware to gain compatibility with older AP's. After deploying the .OVA image and finish the setup, the controller never start the services, never had Webui access ne...
Older ZD3000, how to migrate to SmartZone over time, ie have both controllers up and running
