Due to the power outage, the ICX-7150 switch entered a state commonly referred to as 'boot-mode,' rendering it unable to boot up properly. It's important to note that this doesn't necessarily mean the unit is broken or requires replacement in all cases.
1-For initial troubleshooting, please consider the following steps:
a. Disconnect the ICX-7150 from the power outlet and then reconnect it.
b. Try pressing the reset button using a paperclip or a small stick. Follow these steps:
c. Remove power from the switch.
d. Press and hold the Reset button while applying power to the switch.
f. Release the Reset button after all the system LEDs flash amber. More details can be found https://docs.commscope.com/bundle/icx7150-installguide/page/GUID-D3B5DB74-53A7-4F8D-82F9-6EB600879EE....
Additionally, you can refer to this https://www.youtube.com/watch?v=6jHMTdo_hK4.
2-If the issue persists, we may need to perform a software recovery, as it's possible that the image flash is corrupted, preventing proper boot-up. Follow these steps:
Access the ICX-7150C12P physically using one of the cables, as detailed
https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-console-in-the-ICX-71...
Once connected, attempt to boot up the unit using the commands 'Boot_primary' or 'Boot_secondary.'
3- If the issue persists, consider software recovery by following the steps outlined in https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-perform-a-Software-re....
A helpful video guide is available https://www.youtube.com/watch?v=Ql22blH_CGo.
Best Regards,
Fernando Vasquez
