cancel
Showing results for 
Search instead for 
Did you mean: 

Saving config change on indivdual AP in mesh setup

david_hunt
New Contributor

Hi,

I was hoping to change the default vlan on some of my AP's that have cameras directly connected to them but as I've seen in other posts this isn't available at least in the unleashed version I'm using (200.7)

But I've figured out if I login to the individual AP's I can change this via the rkscli like this

set interface eth0 type vlan-trunk untag 10

set interface eth1 type vlan-trunk untag 10

Is there a way I can save this change? Otherwise I loose it every time the AP reboots. Or does anyone have any other bright ideas on how to do this. I was hoping to avoid having to put switches at these locations just to do vlan tagging.

I've got a combination of R600s, R610s & a T300 so upgrading unleashed versions isn't an option at this stage.

Thanks

3 REPLIES 3

syamantakomer
Community Admin
Community Admin

Management VLAN tagging is not supported on 200.7.

And looking at the APs models, I don't think you can upgrade to higher versions.


Syamantak Omer
Sr.Staff TSE | CWNA | CCNA | RCWA | RASZA | RICXI
RUCKUS Networks, CommScope!
Follow me on LinkedIn

david_hunt
New Contributor

Is there any way I can save the commands I run on the indivdual AP's so they are applied every time they are booted up?

@david_hunt scripting or automating this within the AP is not possible.


Syamantak Omer
Sr.Staff TSE | CWNA | CCNA | RCWA | RASZA | RICXI
RUCKUS Networks, CommScope!
Follow me on LinkedIn