Otherwise, you have to do a password recovery procedure:
- connect to the console switch
- boot up
- stop the boot process at the begin by press 'b' key
- enter 'no password' and 'boot'
- the switch will start normally and you will have acc...
For OSPF to work, you have to enable it globally, and assign interface(s) in the area (the right one if you have several). You have enable it already but you have to go on interface to assign it. So for your setup :
"interface ethernet 1/2/1"
"ip o...
Ok thanks for the provided information.
So here is the issue, your NAT router must be aware of the 10.172.2.0 network. Otherwise it will not be able to route the traffic back to the end-device. There is no NAT on the ICX itself to mask the different...
