CommScope RUCKUS Community Forums

 Ruckus Smart Zone controllers can run a Zone with legacy firmwareExample: a 5.2.2 smart zone controller can support zones with the following firmware versions: SZ 3.6.2 (GD)SZ 5.1SZ 5.1.1SZ 5.1.2SZ 5.2SZ 5.2.1SZ 5.2.2We are following the N-2 rule fo...

The logical interfaces of the Smart Zone are Management, Control, Cluster, and Data. Each can have its own IP address and MAC address. Management: Used to access the Web Interface of the controllerCan be used to SSH into the controller using admin cr...

InformaCast is an emergency mass notification system that sends critical messages to on-premises devices and mobile users, helping keep people safe — by providing notification solutions for every need. This system does not work on Ruckus WLAN's nativ...

WPA/WPA2-based authentication does not work when the Zone director is offline.Clients are unable to connect to the wireless when the zone director is offline.This is expected behavior.In “ZD-managed mode”, APs need a centralized controller to provisi...

Firmware version Make sure both Access points are on the same version SSH to the assets and run the command # get version or # fw show all Make sure that the outputs match and the AP is booted on the right boot partition Gateway detection Make sure...