I'm trying to figure out how to have different MTU's defined on a 7150 or 6450 switch.I've read that I have to enable Jumbo frames on the general configuration label and then restart the switch to enable the support.It appears that the MTU should be ...
I'm working with a 7150-24 port switch in a test environment.I'm looking at how to address potential loops for connected un-managed switches - good or bad, I have to deal with this ugly reality. While loop-detection DOES work, the affected port does...
Have you already configured 802.1x with vlan assignment on your WLAN? Or are you trying to figure out how to set this up across your entire environment?
This can quickly head down a rabbit hole.In a nutshellWindows servers can easily be configured to lease addresses for multiple network segments. (Google is your friend, there's a bunch of how to's for this type of configuration out there)For the ICX ...
These don't seem to auto-detect that there's a 1GB gbic installed.If you're running 7150's on both ends of your link, set the port speed/duplex configuration.e.g. Interface Ethernet 1/3/1 speed-duplex 1000-full-master
Show ntp status shows time an hour off... the clock and logs show the correct time.The boot time is a bit odd - I don't see a similar behavior for the boot time with a 7150 running 8.0.80 code... and NTP seems to show the same behavior.SSH@switch-P...
Wait, so you don't have a console cable. You'll need that to do anything after a factory reset.Had you ever restarted the system after the installation? (perhaps the configuration wasn't saved by whomever installed your smart home package?)If you do ...
