Hi @BusinessUser You can use below commands to add vlans via interface .Please let us know if you are looking for this command.int eth <>vlan-config add tagged-vlan <> And you can use show vlan brief eth <> if you are specifically looking for vlan m...
@1Roeun Please perform the software recovery process mentioned in below document:https://docs.commscope.com/bundle/fastiron-09010-upgradeguide/page/GUID-9B5D5A56-039D-44FB-8FD2-B9B55E71ADE8.htmlRegards,Zairah JaveedSr Technical Support Engineer | L2 ...
Hi @BusinessUser1 ,We can do other configurations by adding to interface but tagging and untagging can be done via vlanRegards,Zairah JaveedSr Technical Support Engineer | L2 TAC Wiredsupport.ruckuswireless.com/contact-usCOMMSCOPEnow meets nextNote: ...
Hello @BusinessUser ,You can use " show vlan " command to check the tag and untag ports associated with particular vlanAlso you can tag /untag the port by going into the vlan and then using tag/untag command #config #vlan <>#tagged/untag ethernet <>E...
Hello @BOBBY21 ,In switch you can run below command to move it to factory default setting:erase system factory-defaultYou can also use below guide in removing the configuration from switch:https://docs.commscope.com/bundle/icx7150-installguide/page/G...
