Hello,You may first want to check the router if these two APs have a valid IP address. If yes, try pinging to these IP addresses from a laptop connected to the router.After that you can try entering the APs IP address in a browser in this format - ht...
Hi @sogalli This could happen if concurrent configuration changes are done due to which the configuration for that zone gets corrupted.May I know the firmware version of your vSZ? Regards,Phiravin
Hi,Yes, if Standalone firmware (110.x or 114.x) is flashed, you should be able to configure it again either as a Standalone or use the "set director ip x.x.x.x" command to connect it back to your Zone Director.Regards,Phiravin
Hi @laeeq2410 You can configure SNMPv2 or SNMPv3 in vSZ. Please refer to the links below.vSZ-E Admin Guide (5.1):https://docs.commscope.com/bundle/sz-510-adminguide-sz100vsz/page/GUID-6D43033C-5149-47C4-BDA8-9E79A00E44F8.htmlvSZ-E SNMP Reference Guid...
