This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
- Community
- RUCKUS Technologies
- RUCKUS Lennar Support
- Community Services
- RTF
- RTF Community
- Australia and New Zealand – English
- Brazil – Português
- China – 简体中文
- France – Français
- Germany – Deutsch
- Hong Kong – 繁體中文
- India – English
- Indonesia – bahasa Indonesia
- Italy – Italiano
- Japan – 日本語
- Korea – 한국어
- Latin America – Español (Latinoamérica)
- Middle East & Africa – English
- Netherlands – Nederlands
- Nordics – English
- North America – English
- Poland – polski
- Russia – Русский
- Singapore, Malaysia, and Philippines – English
- Spain – Español
- Taiwan – 繁體中文
- Thailand – ไทย
- Turkey – Türkçe
- United Kingdom – English
- EOL Products
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
81 results
Sorted by:
03-07-2023
02:15 PM
...I believe that's a tactic used to determine if a device is on a captive network, but is that a feature of Unleashed?
02-23-2023
04:21 PM
I have rogue devices and I'll be honest I'm not really sure what that means - When I go to Services - WIPS - Rogue Devices.
02-24-2023
06:54 AM
Hello, I see under the SSID, if I go to radio control I can enable wifi6 - is there a way to disable the 2.4 and 5ghz on that ssid only?
02-01-2023
09:45 AM
Hi guys, I am brand new to using Ruckus devices and I have an R650 that I need to change from Unleashed to network. Is there a firmware update that I need to install to make the switch? As I u...
12-09-2022
03:03 PM
...raced this down to an old configuration change based on a warning the Unleashed UI would issue and more detail is at https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/Not-e...
12-05-2022
01:33 PM
Running Unleased 200.13.6.1.319 and recently noticed that my R710 is only communicating at 100Mbps. The output from my HP 2530-24G-PoEP switch shows the following: # sh int brief
S...
12-06-2022
02:25 AM
Hi I am new to Ruckus products. I am trying to figure out, how to make a 2.4 Ghz network only. I have som clients that i need to run on 2,4 Ghz, but i can not choose to connect to 2.4 only. So i t...
12-01-2022
08:38 PM
Hello, I have an R650 (I got used). Usually I just reset them to factory defaults, flash them then configure them. This one powers up with the power light, the CTL fl...
11-24-2022
10:34 AM
...ith another longer. Then I will need to enable wlan services (I think I know how to do this) I read this: https://docs.commscope.com/bundle/unleashed-200.10-troublshootingref/page/G...
