cancel
Showing results for 
Search instead for 
Did you mean: 

Not enough electricity power provided with AP warning

rajiv_kumar
New Contributor III

I have the issue on AP R710, 720, 750. Not enough electricity power provided with AP warning

issue. The issue started after updating the unleashed to 200.10 firmware. The issue is on the unleashed firmware 200.8 to 200.10.

On the firmware 200.7 didn't get the warning of "Not enough electricity power provided with AP".

Tried several PoE switches and PoE injector but it doesn't resolve. only after downgrading the unleashed firmware to 200.7 its getting resolve. pls suggest.

16 REPLIES 16

sam_evans
New Contributor III

Does it take 802.3at power on the earlier version of Unleashed with the same exact setup or is it 802.3.af power with no PoE warning? 




yes, 200.7.x is working perfectly in all APs without any error/ warning.

From 200.8.x to 200.10.x its showing error/ warning.

sam_evans
New Contributor III

Hi Rajiv, 

The PoE mode warning feature was introduced in version 200.8, did you verify that the AP was drawing 802.3at power in version 200.7 because there is not a PoE warning in that version.  

Yes, I had checked. 

sam_evans
New Contributor III

Hi Rajiv,

Thanks for confirming.

I would suggest that you open a ticket with Ruckus support so that they can investigate this with you further.

Kind regards,

Sam