Switches
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Resolved! tagging a VLAN on lag port

Hi all, I have an ICX7150 with a lag port that uplinks to a 7650.  I created a new VLAN that I need to tag, so I can have this traffic flow between the two switches. When I do this, do I need to tag the vlan on the lag port, or just on the ether...

L3 config

Hi guys, I have conf icx 48 on L3 firmware as it shows here: telnet@ICX7150-24P Router(config)#sh runCurrent configuration:!ver 08.0.90jT213!stack unit 1  module 1 icx7150-24p-poe-port-management-module  module 2 icx7150-2-copper-port-2g-module  m...

ICX 7250 Enclosure Screw Specifications

Hello Ruckus Community, I am looking for the enclosure screw specifications for the ICX 7250 so I can purchase additional screws. I couldn't find the information in the documentation. Does anyone know what the specifications are? In addition, is it ...

Inter-VLAN Routing to Untagged Interfaces

Hello All - Relatively new to VLANs and am building upon a setup from a previous employee. Initial question: How do I make a device which is untagged in a non-default VLAN be able communicate with the other VLANS? More Details: Our school distr...

Resolved! ICX 7550 web-management support is not available for this device?

I've been trying to enable web management on an ICX7550-48ZP without any luck. At best, when web-management is enabled for HTTP I get a web page with just the message "Web-management support is not available for this device". If I enable web-managem...

louis by New Contributor III
  • 87 Views
  • 3 replies
  • 0 kudos