cancel
Showing results for 
Search instead for 
Did you mean: 

When I add a second port to a existing LAG it is immediately disabled, why?

michael_ridenou
New Contributor II
Link aggregation issue 

Everything appears to be correctly configured for some reason upon addition of the secondary port to the LAG it disables. I have tried everything short of completely eliminating the lag and reconfiguration but would like to avoid that if at all possible. 
6 REPLIES 6

Michael,
Need to get on a call right now.....you most likely have LACP block issue....
http://docs.ruckuswireless.com/fastiron/08.0.70/fastiron-08070-l2guide/GUID-35DFAD56-2479-4FA1-A448-...
Check this out...make sure you meat all criteria for LAG formation......


simon_pollard
Contributor II
Hi Michael

There were changes to LAG operation in release 8.0.61 which may be causing issues as you have 8.0.30 on one node and 8.0.70 on the other. I would recommend upgrading the 8.0.30 node to match the other switch and make sure you have dynamic LAGs configured. Or migrate them both the 8.0.90d.