Hello. I have rspan setup, but noticed on my workstation running Wireshark I'm only receiving outbound traffic from the source device. Without luck I've tried rspan source monitor-both eth 2/1/20 as well as rspan source monitor-in eth 2/1/20 AND rspan source monitor-out eth 2/1/20. I do not have a capture or display filter set on Wireshark. Below is what I have configured. I was wondering if someone could see what I'm missing? Thanks.
Access SW with source device
rspan-vlan 3100 tagged lag 1 [lag 1 is trunk to Core SW] rspan destination lag 1 rspan source monitor-in ethe 2/1/20 rspan source monitor-out ethe 2/1/20 spanning-tree 802-1w
int eth 2/1/20
spanning-tree 802-1w admin-edge-port
tagged lag 1 to lag 48 [all lags are tagged]
Access SW with destination workstation running Wireshark
tagged eth 4/1/10 lag 1 [lag 1 is trunk to Core SW]