cancel
Showing results for 
Search instead for 
Did you mean: 

L3 Premium License Problem

cankaya_univers
New Contributor III

Hello,

I installed l3-prem-2X10G license but my ICX 7250 does not have L3 features. What could be the problem? I reloaded the switch but it is has l2 features, not L3.

ICX7250-48 Switch#show version
  Copyright (c) Ruckus Networks, Inc. All rights reserved.
    UNIT 1: compiled on Jan  5 2021 at 21:06:08 labeled as SPS08090j
      (29360128 bytes) from Primary SPS08090j.bin (UFI)
        SW: Version 08.0.90jT211
      Compressed Primary Boot Code size = 786944, Version:10.1.18T215 (spz10118)
       Compiled on Mon Jul 13 08:53:15 2020

  HW: Stackable ICX7250-48
==========================================================================
UNIT 1: SL 1: ICX7250-48 48-port Management Module
      Serial  #:DUJ3--------
      Software Package: BASE_SOFT_PACKAGE   (LID: fwlIHGIuFFn)
      Current License: l3-prem-2X10G
      P-ASIC  0: type B344, rev 01  Chip BCM56344_A0

1 ACCEPTED SOLUTION

corey_costello
New Contributor III

Your booting from switch code. 

check your flash and if you have SPR as secondary,

run

”boot system flash secondary yes”

this will instantly reboot the switch, make sure this is lab only. 

View solution in original post

6 REPLIES 6

corey_costello
New Contributor III

Your booting from switch code. 

check your flash and if you have SPR as secondary,

run

”boot system flash secondary yes”

this will instantly reboot the switch, make sure this is lab only. 

This is not lab. I am building the campus network. 

ICX7250-48P Switch#show flash
Stack unit 1:
  Compressed Pri Code size = 29360128, Version:08.0.90jT211 (SPS08090j.bin)
  Compressed Sec Code size = 33554432, Version:08.0.90jT213 (SPR08090j.bin)
  Compressed Pri Boot Code size = 786944, Version:10.1.18T215 (spz10118)
  Compressed Sec Boot Code size = 786944, Version:10.1.18T215 (spz10118)
  Code Flash Free Space = 1689579520

ICX7250-48P Switch#show boot-preference
Boot system preference(Configured):
        Use Default

Boot system preference(Default):
        Boot system flash primary
        Boot system flash secondary

These are new products. How can I solve it?

Alright, Primary is l2 firmware so that was the reason. I will copy secondary to primary and solve the problem.

Yep! That's your fix. Sorry for the delayed response.