cancel
Showing results for 
Search instead for 
Did you mean: 

How to perform a hard reset on icx 7450?

yawovi_akakpo
New Contributor
How to perform a hard reset on icx 7450? I tried this procedure but it did not work:
1 Remove power from the switch.
2 Press and hold the reset button and apply power to the switch.
3 Release the reset button after all of the system LEDs flash amber.
10 REPLIES 10

netwizz
Contributor III
I think the reset button acts differently before 08.0.70 build families.  It might have erased only the password.

Put in a console cable and see if you can enable and then do a erase startup-config.

****

If not, you can reboot it and at some point will be asked to press b to enter the boot monitor mode...


If you do that you can then enter

no password
boot


From there once it boots...

enable
erase startup-config

james_schena
New Contributor II
If you really want to reset the device and not just PW recover you can try this as well:


stop boot process with break sequenced "b" to enter boot mode
!
factory set-default
!
boot system flash primary

simon_pollard
Contributor II
The reset sequence using the front panel button was introduced in 8.0.70 so it will not work if the 7450 is using an earlier release and you will need to use the method described by James.

From 8.0.80 you can also use the erase system factory-default command at the enable prompt.

yawovi_akakpo
New Contributor
The issue is, i can't access the console to do a erase startup-config. When i boot or reboot the device, no output in putty. yes i changed the port speed rate. I used the USB port and mgnt port.