Hopefully someone has found a fix for my issue and I just haven't found it on the forums,
Home was built by lennar in 2018 has n R510 AP and icx 7150 c12p switch, been working fine since until two days ago power surge hit the neighborhood and when i was waiting on everything to boot back up the syst light is stuck on amber and when i try to console in via usb type c i cant detect the switch. Not even the little "bing" when plugging in a usb cable to the pc.I installed the CP210x drivers but still nothing is recognized on the pc. Also tried the reset process on the switch and nothing has changed. Read and re-read the detailed forum post on how to console in. Was able to ssh into it using putty once before to update image so it is visible in the unleashed app once before.
Any help would be much appreciated. I took the switch to a a network professional and they too were unable to console in. The pc being used does not recognize a connection when plugged in to a usb port using usb-c to usb-a cable.
Thank you for contacting RUCKUS Lennar Home Community.
Hope you are doing well!!!
Thank you for the information you shared.
As per the case description, I understand that your RUCKUS setup is not working, after a power surge and there is an Amber light on SYST.
As you mentioned there is an Amber light on SYST, if there is an amber/orange light on the "SYST" and a green light on the "PWR" on the Switch (as it is in the below picture). Meaning the Switch is stuck in the boot mode.
Basically, due to the power outage/ power spike, the switch went to a state that we call ‘boot mode’ that is not able to boot up properly.
Please follow the below steps to fix this issue:
As you mentioned that you tried resetting, once again we will try to reset the Switch as described below and in VIDEO:
1. Please try to disconnect from the Power outlet the ICX-7150 and reconnect.
2. Please try to press the reset button using a paper click or a small stick
Remove power from the switch.
Press and hold the Reset button while applying power to the switch.
After all the system LEDs flash amber, release the Reset button.
Below is the Guide and Videos link for your reference:
IF THE RESET IS NOT WORKING, PLEASE TRY TO RESET YOUR SWITCH MULTIPLE TIMES (Like 10-15 times) AS DESCRIBED ABOVE. As we have seen it working sometimes after trying multiple times in many cases. If the reset with a paperclip works, the SYST and PWR lights should turn GREEN.
IF RESET DOESN’T WORK: Please follow the below steps.
If the reset does not make any difference, we need to perform a software recovery since it can be that the image flash is corrupted in basic words the unit is not able to boot up properly and needs to re-install the image to boot up properly.
Below is the Guide and Video Link to perform the Software recovery process:
Well I performed the reset sequence 16 times, just for good measure,and allowed for about 3 minutes I between reset cycles however it’s gotten a little late for me and I’ll have to try the software recover process tomorrow since it doesn’t appear that resetting the switch multiple times has resolved the issue