After factory reset an working R510, it can't be seen on staging zone of the smartzone

[andrew_labrunda]

I factory reset the R510 which was already in use/online in Smartzone 3.6 and the AP firmware was 3.6.2.0.254. I deleted the AP from the existing zone and hoping after factory reset the AP, it will show up on the staging zone again, but it never did.

[andrew_labrunda]

just figured out, the problem was the uplink switch. Disregard this question.

[eizens_putnins]

AP shows in staging zone, when it sends request to SZ. AP must know SZ IP for that (manually configured sz IP, or recieved from DHCP option 43 or DNS).