1200 zonedirector unable to reset...

wcutler — Thu, 21 Nov 2024 15:12:06 GMT

I have 2 1200 zonedirectors that I am unable to factory reset them. When turned on the status and power lights turn green immediately. with an ethernet cable connected to port 1 both port lights turn green but do not blink.

I have pushed the f/d button from 5 to 30 seconds and nothing happens. I have tried doing the same to the reset button. Nothing happens. Are these devices bad or is there some specific way to make these devices reset?

Thanks,

Wayne

Re: 1200 zonedirector unable to reset...

sagar_kuber — Fri, 22 Nov 2024 11:07:28 GMT

Hi Wayne,

I see that you have already tried below method to factory reset the units. The units seem to have gone faulty. I would suggest you to raise a support case for RMA.

The RMA will be processed as per support entitlement of the unit.

Hard reset:

Locate the Reset pin hole on the front panel of the ZD
Insert a straightened paper clip into the hole
Press and hold the paper clip for at least 5 seconds
The Status LED will blink red, then green, when the reset is complete
After completing the Setup Wizard, the Status LED will be steady green

Regards,
Sagar Kuber
Sr. Technical Support Engineer

topic Re: 1200 zonedirector unable to reset... in ZoneDirector

1200 zonedirector unable to reset...

Re: 1200 zonedirector unable to reset...