Cannot get R510 to Join VLAN from ZD1200

steve_hensyel — Thu, 05 Oct 2023 21:33:40 GMT

I am trying to add a new R510 AP to a ZD1200 and cannot get it to see VLAN 2.

The current APls that are on there and configured and working show VLAN 2 under their info page. (They are T300 and R500).

The ZD1200 sees the new R510 AP and says it is connected and has an IP of 10.34.14.74

The switch port for the new ap are 2UP and the ZD1200 can see it. If I change this to the same port settings as the other AP's then the ZD1200 cannot see it.

The new AP shows VLAN 2 10:f0:68:3e:6d:40 GE1/19 in the switch MAC addr table

The working AP's have a switch port with 2T, 14UP, 60T, 70T.

Pic of AP T300 showing VLAN 2

Pic of R510 showing VLAN 1

Re: Cannot get R510 to Join VLAN from ZD1200

syamantakomer — Thu, 05 Oct 2023 21:31:47 GMT

Hi Steve,

Looks like configuration issue.

Could you check below configuration.

Check what the VLAN set for AP management in ZD.
Make sure same set of VLANs are allowed on switch port trunk.
Make sure AP eth port is set to Trunk, not access.
1. get interface eth0

topic Cannot get R510 to Join VLAN from ZD1200 in ZoneDirector

Cannot get R510 to Join VLAN from ZD1200

Re: Cannot get R510 to Join VLAN from ZD1200