https://community.ruckuswireless.com/t5/ZoneDirector/Auto-install-of-ZoneDirector-possible/m-p/43751#M7907 A factory defaulted ZoneDirector, not connected to a network, will come up with the <BR /> default IP 192.168.0.2. You typically attach a pre-configured PC with 192.168.0.x <BR /> address, and use <A href="https://192.168.0.2" rel="nofollow">https://192.168.0.2</A> to configure the ZD thru the Setup Wizard. <BR /><BR /> When connected to a network with a DHCP server, the ZD will pull a DHCP IP <BR /> address, and you will need to find the ZD's MAC address on the server to determine <BR /> it's IP address then. Just the same, when you HTTPS into the ZD, you will have to <BR /> configure initially thru the Setup Wizard. While Ruckus is working on a text config <BR /> backup/restore, this is still a Feature Request at this time, so no auto-configuration <BR /> is possible at this date. Thu, 19 Jun 2014 23:02:30 GMT michael_brado 2014-06-19T23:02:30Z https://community.ruckuswireless.com/t5/ZoneDirector/Auto-install-of-ZoneDirector-possible/m-p/43750#M7906 When a ZoneDirector boots up, does it perform DHCP requests by default? I'm interested in pre-configuring DHCP on routers at remote locations, then sending an install team. The idea is to open a fresh box and just plug it in, with no configuration of the individual ZD by the installer (or by a pre-staging team). I'd like to have DHCP direct the ZD to a TFTP server with the filename of a pre-generated configuration file for that location. Is this possible with Ruckus? We previously did this with our Cisco solution that we are looking to replace. Wed, 18 Jun 2014 12:08:19 GMT https://community.ruckuswireless.com/t5/ZoneDirector/Auto-install-of-ZoneDirector-possible/m-p/43750#M7906 paul_taylops 2014-06-18T12:08:19Z https://community.ruckuswireless.com/t5/ZoneDirector/Auto-install-of-ZoneDirector-possible/m-p/43751#M7907 A factory defaulted ZoneDirector, not connected to a network, will come up with the <BR /> default IP 192.168.0.2. You typically attach a pre-configured PC with 192.168.0.x <BR /> address, and use <A href="https://192.168.0.2" rel="nofollow">https://192.168.0.2</A> to configure the ZD thru the Setup Wizard. <BR /><BR /> When connected to a network with a DHCP server, the ZD will pull a DHCP IP <BR /> address, and you will need to find the ZD's MAC address on the server to determine <BR /> it's IP address then. Just the same, when you HTTPS into the ZD, you will have to <BR /> configure initially thru the Setup Wizard. While Ruckus is working on a text config <BR /> backup/restore, this is still a Feature Request at this time, so no auto-configuration <BR /> is possible at this date. Thu, 19 Jun 2014 23:02:30 GMT https://community.ruckuswireless.com/t5/ZoneDirector/Auto-install-of-ZoneDirector-possible/m-p/43751#M7907 michael_brado 2014-06-19T23:02:30Z