topic Re: DHCP issue in ruckus AP in ZoneDirector

DHCP issue in ruckus AP

abhinav_kumar_7 — Sat, 07 Feb 2015 07:03:01 GMT

Hi all

i have created two ssid say abc1 with vlan 20 and abc2 with vlan30

when user connects to abc1 , they are connected and recieves ip of vlan 20

But when the Users connect to abc2 , they are not recieving the ip .

The dhcp server is located on the physical server .

Please suggest where is the issue

Re: DHCP issue in ruckus AP

monnat_systems — Sat, 07 Feb 2015 13:07:58 GMT

Hi Abhinav,

I would like you to refer to below old post and this shall provide you some guidance

https://forums.ruckuswireless.com/ruc...

If this does not help please get back here so that I can give a fresh shot.

Hope this helps.

Re: DHCP issue in ruckus AP

abhinav_kumar_7 — Mon, 09 Feb 2015 08:26:46 GMT

HI thanks

No, still i am in issue . please suggest

As two ssid are connected and the Users are recieving the IP and bu with the Third SSID Unable to get the Ip

Re: DHCP issue in ruckus AP

munish_munish — Mon, 09 Feb 2015 08:29:50 GMT

Hi Abhinav,

What if you hardwire the client in to the same VLAN ? Do you get ip address?

Thanks

Re: DHCP issue in ruckus AP

abhinav_kumar_7 — Mon, 09 Feb 2015 09:45:24 GMT

yes i get the Ip

Re: DHCP issue in ruckus AP

monnat_systems — Mon, 09 Feb 2015 16:49:35 GMT

Hi Abhinav,

Is there any restrictions on that switch port? Can you reset that port and just config basic VLAN and recheck?

Also if you connect the AP back and do the test with a wireless client. Is it possible to do PORT SPAN to see if you see DHCP discover from client or not and DHCP server responses or not?

Re: DHCP issue in ruckus AP

munish_munish — Tue, 10 Feb 2015 06:34:35 GMT

Hi Abhinav,

Agree with Monnat, Check the VLAN configuration and I would also suggest to collect a packet trace from the br0 interface of the AP the client connect to, and check to see does DHCP server reply to client Discovers?
br0 will show you both Eth and Wireless interface traffic.

Thanks
Munish