topic Re: SZ100 not pinging after reset in ZoneDirector

SZ100 not pinging after reset

abdullah_zia_76 — Thu, 04 Feb 2016 08:05:38 GMT

i am changing the management ip to 192.168.1.1 to another network 192.168.11.1 but got error message something like "ip cannot change static route not defied " like that

than I reset the ZS100 and now its default ip is not pinging and status light is gree.

Re: SZ100 not pinging after reset

martin_martin — Thu, 04 Feb 2016 09:48:19 GMT

Hi,
I assume you mean the SZ100
If so, take a console cable and connect it up, and check via serial link.

Login to the device and do a show interface.
This will give you the current ip address assigned to the device.

Kind regards
Martin

Re: SZ100 not pinging after reset

abdullah_zia_76 — Thu, 04 Feb 2016 10:24:32 GMT

i connected the cisco console with com1 port but no response

Re: SZ100 not pinging after reset

abdullah_zia_76 — Thu, 04 Feb 2016 10:29:14 GMT

the status led is red when port 1 not connected to any switch.
status led turned red when port 1 is connected to switch
????

Re: SZ100 not pinging after reset

martin_martin — Thu, 04 Feb 2016 12:28:40 GMT

Hi Abdullah,

Do you have the serial connection good ? and also like putty to comx: ?

If so, power off the SZ100 and wait 10 sec, and then back on. You should see the bootup process of the unit.

Kind regards
Martin

Re: SZ100 not pinging after reset

abdullah_zia_76 — Wed, 10 Feb 2016 08:06:41 GMT

yeah i restarted and saw the symbols on the screen but cant type any thing.
and tell me how to set SZ100 to factory default