https://community.ruckuswireless.com/t5/ZoneDirector/Zone-director-3000-support-LAG/m-p/34247#M6231 Hello, <BR /><BR />I just updated this article:<BR /><BR /><A href="https://support.ruckuswireless.com/answers/000002296" rel="nofollow" target="_blank" title="Link https//supportruckuswirelesscom/answers/000002296">https://support.ruckuswireless.com/answers/000002296</A><BR /><BR />The two Ethernet ports on a ZoneDirector are each 1gig capable, but the two Physical interfaces are one Logical<BR />interface to the ZoneDirector.<BR /><BR />You can connect each ZD interface to a separate network switch, but Spanning Tree should block one of the switch<BR />port paths to prevent the ZD MAC address from being seen on it's other interface, forming a loop. <BR /><BR />This provides High Availability for uptime purposes, in the event that a cable/interface/switch went bad or went down,<BR />but we cannot transmit/receive traffic over both ZD interfaces simultaneously (Load Balancing / Link Aggregation). Thu, 06 Aug 2015 17:17:50 GMT michael_brado 2015-08-06T17:17:50Z https://community.ruckuswireless.com/t5/ZoneDirector/Zone-director-3000-support-LAG/m-p/34246#M6230 Zone director 3000 support LAG or not ?&nbsp; Thu, 06 Aug 2015 08:40:29 GMT https://community.ruckuswireless.com/t5/ZoneDirector/Zone-director-3000-support-LAG/m-p/34246#M6230 wipawee_paiboon 2015-08-06T08:40:29Z https://community.ruckuswireless.com/t5/ZoneDirector/Zone-director-3000-support-LAG/m-p/34247#M6231 Hello, <BR /><BR />I just updated this article:<BR /><BR /><A href="https://support.ruckuswireless.com/answers/000002296" rel="nofollow" target="_blank" title="Link https//supportruckuswirelesscom/answers/000002296">https://support.ruckuswireless.com/answers/000002296</A><BR /><BR />The two Ethernet ports on a ZoneDirector are each 1gig capable, but the two Physical interfaces are one Logical<BR />interface to the ZoneDirector.<BR /><BR />You can connect each ZD interface to a separate network switch, but Spanning Tree should block one of the switch<BR />port paths to prevent the ZD MAC address from being seen on it's other interface, forming a loop. <BR /><BR />This provides High Availability for uptime purposes, in the event that a cable/interface/switch went bad or went down,<BR />but we cannot transmit/receive traffic over both ZD interfaces simultaneously (Load Balancing / Link Aggregation). Thu, 06 Aug 2015 17:17:50 GMT https://community.ruckuswireless.com/t5/ZoneDirector/Zone-director-3000-support-LAG/m-p/34247#M6231 michael_brado 2015-08-06T17:17:50Z