https://community.ruckuswireless.com/t5/ZoneDirector/MIgration-from-ZD3050-to-SZ100/m-p/28980#M5610 Hi Ricardo,<BR />&nbsp;&nbsp; No interim re-flashing AP code is necessary, if using current SmartZone firmware<BR />which has an 'lwapp2scg' process enabled by default since SZ 2.5.0.1.x, 2.6+, 3.0+. Fri, 14 Apr 2017 20:56:26 GMT michael_brado 2017-04-14T20:56:26Z https://community.ruckuswireless.com/t5/ZoneDirector/MIgration-from-ZD3050-to-SZ100/m-p/28979#M5609 Hi,<BR /><BR />I was checking the migration guide to migrate from a Zone Director to a SmartZone:<BR />zd-to-scg-vscg-sz-ap-migration-rg-20150417<BR /><BR />I want to migrate a site with around 600 APs and I don't want to have to factory reset and install a Solo FW.<BR /><BR />Do you know if this is still the correct guide or if there is a newer one?<BR /><BR />Thanks,<BR />Ricardo Wed, 12 Apr 2017 11:11:24 GMT https://community.ruckuswireless.com/t5/ZoneDirector/MIgration-from-ZD3050-to-SZ100/m-p/28979#M5609 ricardo_reynaud 2017-04-12T11:11:24Z https://community.ruckuswireless.com/t5/ZoneDirector/MIgration-from-ZD3050-to-SZ100/m-p/28980#M5610 Hi Ricardo,<BR />&nbsp;&nbsp; No interim re-flashing AP code is necessary, if using current SmartZone firmware<BR />which has an 'lwapp2scg' process enabled by default since SZ 2.5.0.1.x, 2.6+, 3.0+. Fri, 14 Apr 2017 20:56:26 GMT https://community.ruckuswireless.com/t5/ZoneDirector/MIgration-from-ZD3050-to-SZ100/m-p/28980#M5610 michael_brado 2017-04-14T20:56:26Z