topic Re: Save AP names after a zonedirector factory default. in ZoneDirector

Save AP names after a zonedirector factory default.

salvatore_busce — Mon, 30 Sep 2013 14:30:25 GMT

I need to factory default a zonedirector to disable mesh, but I have 250 APs named. Is there any way to save that info, and upload it after the zonedirector is reconfigured?

Re: Save AP names after a zonedirector factory default.

primoz_marinsek — Mon, 30 Sep 2013 18:24:46 GMT

RTFM :)

There is a restore feature. When you restore you have the option to restore just some stuff not all.

Re: Save AP names after a zonedirector factory default.

salvatore_busce — Wed, 02 Oct 2013 13:29:32 GMT

I dont see an option for "restore everything except mesh settings" which is what I need to do.

Restore everything.

Restore everything, except system name and IP address settings (for failover deployment at the same site).

Restore only WLAN settings, access control list, roles, and users (use this as a template for different sites).

Re: Save AP names after a zonedirector factory default.

primoz_marinsek — Thu, 03 Oct 2013 06:18:20 GMT

RFM some more :)

Check under "Using Limited ZD Discovery for N+1 Redundancy"

Re: Save AP names after a zonedirector factory default.

salvatore_busce — Thu, 03 Oct 2013 16:05:09 GMT

I went ahead and did it, and the APs stored their names, so all is well. Thanks for the help!

Re: Save AP names after a zonedirector factory default.

primoz_marinsek — Fri, 04 Oct 2013 05:41:06 GMT

Hey, it was you that did the work.