https://community.ruckuswireless.com/t5/Wireless-Questions-and-Best/Zonedirector-1200-bricked/m-p/69794#M2279 <P>Hi&nbsp;<a href="https://community.ruckuswireless.com/t5/user/viewprofilepage/user-id/19793">@vpelliccia58</a>,<BR /><BR />If you have tried to hard reset the Zone Director and tried to power it On using a different power adapter and still facing the same issue then please raise a support Case with us to initiate the RMA.&nbsp;</P><P>Below are the steps to hard reset the Zone director.&nbsp;<BR />- Locate the Reset pinhole on the front panel of the Zone director.<BR />- Insert a paper clip or any point object into the RESET hole and press &amp; hold it for 15-20 seconds.<BR />- This factory defaults the ZD.<BR />- Now the ZD can be accessed using its default IP address 192.168.0.2 by directly connecting to a PC in the same subnet.<BR />-After the reset completes, the status LED blinks red and then turns green indicating that the system is in a factory default state.</P><P>If the device still does not power on, it can be concluded that the device is defective and I will proceed with an RMA.</P><P>Thank you!<BR />Amith&nbsp;</P> Sun, 15 Oct 2023 08:46:37 GMT Amith 2023-10-15T08:46:37Z https://community.ruckuswireless.com/t5/Wireless-Questions-and-Best/Zonedirector-1200-bricked/m-p/69768#M2278 <P>Zonedirector 1200 bricked / Can get a ZONEDIR 3025 faster. is this a good move?</P> Fri, 13 Oct 2023 15:49:53 GMT https://community.ruckuswireless.com/t5/Wireless-Questions-and-Best/Zonedirector-1200-bricked/m-p/69768#M2278 vpelliccia58 2023-10-13T15:49:53Z https://community.ruckuswireless.com/t5/Wireless-Questions-and-Best/Zonedirector-1200-bricked/m-p/69794#M2279 <P>Hi&nbsp;<a href="https://community.ruckuswireless.com/t5/user/viewprofilepage/user-id/19793">@vpelliccia58</a>,<BR /><BR />If you have tried to hard reset the Zone Director and tried to power it On using a different power adapter and still facing the same issue then please raise a support Case with us to initiate the RMA.&nbsp;</P><P>Below are the steps to hard reset the Zone director.&nbsp;<BR />- Locate the Reset pinhole on the front panel of the Zone director.<BR />- Insert a paper clip or any point object into the RESET hole and press &amp; hold it for 15-20 seconds.<BR />- This factory defaults the ZD.<BR />- Now the ZD can be accessed using its default IP address 192.168.0.2 by directly connecting to a PC in the same subnet.<BR />-After the reset completes, the status LED blinks red and then turns green indicating that the system is in a factory default state.</P><P>If the device still does not power on, it can be concluded that the device is defective and I will proceed with an RMA.</P><P>Thank you!<BR />Amith&nbsp;</P> Sun, 15 Oct 2023 08:46:37 GMT https://community.ruckuswireless.com/t5/Wireless-Questions-and-Best/Zonedirector-1200-bricked/m-p/69794#M2279 Amith 2023-10-15T08:46:37Z