topic Ruckus Ap configuration without controller in Wireless Questions and Best Practices

Ruckus Ap configuration without controller

user_unix — Sat, 16 Mar 2019 08:51:12 GMT

Hey Everyone, I want to ask if is there any windows logiciel to configure Ruckus Ap without controller. And Thanks.

Re: Ruckus Ap configuration without controller

Anusha_Vemula — Mon, 18 Mar 2019 10:14:41 GMT

Hi,

Ruckus APs can also be configured in standalone mode without controllers. However, they should have a standalone firmware running on them.

You can download the firmware from our support site using below link based on the AP model you have.

https://support.ruckuswireless.com/software

Regards,
Anusha

Re: Ruckus Ap configuration without controller

user_unix — Sat, 23 Mar 2019 19:55:44 GMT

Thanks

Re: Ruckus Ap configuration without controller

joie_elmedorial — Thu, 12 Mar 2020 20:43:54 GMT

and how can you update the Firmware without a controller. Like for example I have 30 APs do I need to update each one manually? is there a way to update them once?

Re: Ruckus Ap configuration without controller

sergiosoto78 — Thu, 26 Nov 2020 18:01:46 GMT

I have the same issue and no one has been able to give a answer. Most of the solutions they give me is to reset them but you can’t ssh in or telnet in

Re: Ruckus Ap configuration without controller

michiel_breur — Fri, 27 Nov 2020 23:18:58 GMT

Can't you just press the reset button on the back? That's what i do, and from there flash them to Unleashed firmware. Yes it takes some time but it's worth it.

Re: Ruckus Ap configuration without controller

sergiosoto78 — Fri, 27 Nov 2020 23:55:12 GMT

I wish it was that easy but unfortunately it is not I flashed the switch which was not a problem but with the access points you are not able to SSH in and the default 192.168.0.1 IP address does not work. And two clarify on the SSH even once reset, the default login and password do not work doesn’t matter if you hold the button down for five seconds or a minute. it will not reset back to factory specs sooooo there is no way to login and flash the new firmware

Re: Ruckus Ap configuration without controller

hardwareman — Thu, 02 Feb 2023 18:25:38 GMT

Once you reset them, they have a default IP and default credentials on the back. Connect to them hardwire using a system with a system configured on the AP's default subnet. Log into it using the https web interface (port 443, I believe) and you can configure them from there.