Show Commands on Rukus AP

kasonde — Mon, 09 Sep 2024 15:16:16 GMT

I would like to know the commands to show configs on an AP,

I would like to know the status on HTTP and HTTPs status from cli.

Whats the command for that??

Re: Show Commands on Rukus AP

Vásquez_Fer — Wed, 11 Sep 2024 12:35:34 GMT

Hello kasonde

To know the status of https and http are get https and get http

Here are the commands to run in a Master Access Points

ruckus> enable
ruckus# ap-mode
You have all rights in this mode.

ruckus(ap-mode)# get https
HTTPs access is enabled
But the service is off, it is turned off to save memory once AP is managed by SCG!
If you need the service, please enable again by command "set https/http enable"!
OK
ruckus(ap-mode)# get http
HTTP access is disabled

If you need to verify on a Member access please do the command directly

rkscli:get https

Best Regards

Fernando Vasquez

topic Show Commands on Rukus AP in Unleashed

Show Commands on Rukus AP

Re: Show Commands on Rukus AP