topic Re: Switching an R650 from Unleashed to Network in Unleashed

Switching an R650 from Unleashed to Network

tradley — Wed, 01 Feb 2023 18:07:12 GMT

Hi guys, I am brand new to using Ruckus devices and I have an R650 that I need to change from Unleashed to network. Is there a firmware update that I need to install to make the switch?

As I understand it, ‘Unleashed’ and ‘standalone’ are the same. Unleashed means it is operating as a standalone device. We want the R650 to be part of network of APs that are managed through the SZ144. I believe this takes different f/w – at the least , different settings so it knows to look for and receive instructions from SZ144.

Any help will be greatly appreciated.

Thanks, Thomas

Re: Switching an R650 from Unleashed to Network

vijaykuniyal — Thu, 02 Feb 2023 00:55:15 GMT

Hi @tradley,

Unleashed and Standalone are 2 different firmware.

Firmware version starting with 200.X.X.X is unleashed.
Firmware version starting with 11X.X.X.X is standalone.

For converting Unleashed AP to SZ/vSZ manged AP , you will need to convert the AP to standalone first using the below firmware, which can be done from Unleashed GUI.

https://support.ruckuswireless.com/software/2767-ruckus-solo-access-point-114-0-0-0-6565-ga-software-release-r650

Once AP is converted to standalone firmware, you can configure AP to join vSZ from AP cli using below command.

rkscli:set scg ip <SZ-IP>

after joining the SZ AP will download the required firmware from SZ.

Re: Switching an R650 from Unleashed to Network

tradley — Thu, 02 Feb 2023 16:35:54 GMT

Hi @vijaykuniyal

Thank you so much, I really appreciate the assistance.

Thomas

Re: Switching an R650 from Unleashed to Network

vijaykuniyal — Thu, 02 Feb 2023 16:42:45 GMT

Hi @tradley,

Acknowledge, you can accept this as solution if your issue is fixed with the information.

Re: Switching an R650 from Unleashed to Network

Feri — Wed, 13 Sep 2023 09:53:18 GMT

I understand that the R650 APs loaded with the unleashed firmware need to be converted to standalone APs first by uploading a 11x.x.x.x firmware but when I try this on the unleashed interface under admin and services - administration - upgrade I get a "The uploaded software version is 114.0.0.0.6565, doesn't match with Master AP's 200.7.10.202.141, please choose the same version as Master AP." message.

I can't use the R650s because their oldest unleashed firmware (R650-200.9.10.4.202.bl7) is newer version than the master controllers.

The master controllers are R500 on the latest unleashed firmware (R500_200.7.10.202.141.bl7).

Any assistance is greatly appreciated.

Re: Switching an R650 from Unleashed to Network

Parik_MN — Wed, 13 Sep 2023 10:44:28 GMT

Hello @Feri,

Both R500s and R650s cannot be managed in the same Unleashed network. As R500s are already end of life for a while. It is suggested to managed two different Unleashed network on different/latest compatible firmware.

Regards,

Parik

Re: Switching an R650 from Unleashed to Network

IT — Tue, 26 Nov 2024 17:05:02 GMT

before applying standalone firmware you need to restore the AP to its default configurations