topic Re: connect Ruckus R320 with Cisco switch in Unleashed

connect Ruckus R320 with Cisco switch

chidung_nguyen — Fri, 15 May 2020 09:22:54 GMT

I have Ruckus R320 and I connect it with Cisco switch, but it not connect, so in Cisco switch I need add management vlan ?
my config in Cisco:
"switchport trunk allowed vlan 2,10,15,30,205
switchport trunk native vlan 999
switchport mode trunk
switchport nonegotiate"
management vlan is 205.
Thanks a lot!

Re: connect Ruckus R320 with Cisco switch

arun_nagaraj — Fri, 15 May 2020 09:25:46 GMT

Hi Nguyen,

Can you please let us know from which Vlan you want the Ap to get an ip address from. Is it 999 or 205.

When the AP is connected to switch it will try to get ip address from Native Vlan.

Regards,
Arun N

Re: connect Ruckus R320 with Cisco switch

chidung_nguyen — Fri, 15 May 2020 09:29:04 GMT

I want AP get IP from vlan 205, that is vlan management.

Re: connect Ruckus R320 with Cisco switch

arun_nagaraj — Fri, 15 May 2020 10:02:29 GMT

Hi Nguyen,

Do you have any SZ/vSZ in the network to manage this R320 Ap or is it running as a standalone AP.

Regards,
Arun N

Re: connect Ruckus R320 with Cisco switch

arun_nagaraj — Fri, 15 May 2020 10:20:01 GMT

Hi Nguyen,

If the AP is running as standalone.

Please connect the Ap directly to your laptop and access the AP with its default Ip address 192.168.0.1. Login to Ap CLI using default username and password. Once you login, you can use the below command to check the Vlan and then connect it to the cisco switch.

set ipaddr wan vlan

Regards,
Arun N

Re: connect Ruckus R320 with Cisco switch

chidung_nguyen — Thu, 21 May 2020 07:30:33 GMT

hi Arun N!
Thanks for help, I aready follow your guide, however I still can not connect with AP ruckus R320, AP running Unleshed ( this AP is not master).

Re: connect Ruckus R320 with Cisco switch

arun_nagaraj — Thu, 21 May 2020 07:35:37 GMT

Hi Nguyen,

Can you please share the output of the following command.

get ipaddr wan

Regards,
Arun N

Re: connect Ruckus R320 with Cisco switch

chidung_nguyen — Thu, 21 May 2020 08:59:15 GMT

my command inmage. I see it use vlan1, but I want set vlan 205 for this AP.

Re: connect Ruckus R320 with Cisco switch

arun_nagaraj — Thu, 21 May 2020 09:02:55 GMT

Hi Nguyen,

The Vlan is still 1, it is not changed to 205. Only when you change it to 205, the AP will get an Ip address from 205 and connect to the network. As per your setting on Cisco switch.

I would recommend you to please open a case with our Support team, so that we can help you out on a remote session.

You can use the following link to open a case

https://support.ruckuswireless.com/contact-us

Regards,
Arun N

Re: connect Ruckus R320 with Cisco switch

chidung_nguyen — Thu, 21 May 2020 09:25:49 GMT

hi Arun N!

Thanks so much, your information very helpful