topic Re: 200.11.10.5.195 Broken AD Login? in Unleashed

200.11.10.5.195 Broken AD Login?

Anonymous — Fri, 19 Nov 2021 10:21:06 GMT

I recently upgrade to the lastest 200.11.10.5.195, once the AP rebooted I suddenly could no longer login. The login screen would take the username and password, turn it to starts, and then just sit there and flicker. I had to factory reset to get back into the AP. SSH also would just timeout trying to login. Then I tried to re-setup AD login, and it would do the exact same thing. Then after ssh-ing in with local credentials I went to debug mode, and when I run "logs winbind 1" I get the following.

killall: winbindd: no process killed
sh: winbindd: not found

Was winbindd not put into this image?

Re: 200.11.10.5.195 Broken AD Login?

Anonymous — Fri, 19 Nov 2021 11:50:49 GMT

I rolled back to 200.10.10.5.253, and everything worked right away.

Re: 200.11.10.5.195 Broken AD Login?

Ratnadeep — Fri, 19 Nov 2021 12:10:57 GMT

Hi Dan,

Thanks for reaching out to Ruckus. We might need to replicate the same in lab to find out the root cause, because it's perfectly fine on 200.10.x version.

The command you mentioned "logs winbind 1", is it a shell command? I haven't found this in our Unleashed CLI Guide for any version.

Re: 200.11.10.5.195 Broken AD Login?

Anonymous — Fri, 19 Nov 2021 15:27:17 GMT

@Ratnadeep

I went into enable mode, then debug, then ran "logs winbind 1". But I think this may be a red herring because I just tried it on 200.10 and it gave me the same results with AD login working.

Re: 200.11.10.5.195 Broken AD Login?

syamantakomer — Fri, 19 Nov 2021 15:40:31 GMT

Hi Dan,

If its a Linux command, it will not work because you are in Ruckus CLI, which is running on top of Linux.

I suggest you to open a case with support and we can look into the issue.

@Ratnadeep check once if you are able to reproduce this in lab.

Re: 200.11.10.5.195 Broken AD Login?

Vineet_nejwala — Mon, 22 Nov 2021 04:44:56 GMT

@dan_b

Winbindd output is normal and can be ignored. I would suggest to open Ruckus TAC case and in addition you can enable below logs and provide the output on case. Once the debug is enable try login using AD credential for data to get captured on CLI.

ruckus(debug)# logs level <1-10>

ruckus(debug)# logs play --> This will start debug data

ruckus(debug)# no logs play -- To stop debug

There are two probability, one that somehow the previous upgrade broke AD login for this setup(if issue doesn't show post another upgrade) or if this happens after update again there could be an issue with the 200.11 software and needs to fixed by our side.

Best Regards

Vineet

Staff TSE

Re: 200.11.10.5.195 Broken AD Login?

CRSR — Tue, 19 Jul 2022 07:56:13 GMT

Same thing with the latest R850 and 200.12.10.105.129. I spent hours debugging why TLS would not work (I've setup Unleashed on about 10 other branch offices -- never experienced this before but then again never ran anything past 200.10.xxx). Downgraded to 200.10.10.5.253 and it worked fine - same exact config/settings.