topic Configuring Unleashed’s auto reboot threshold? in Unleashed

Configuring Unleashed’s auto reboot threshold?

john_d — Fri, 28 May 2021 17:46:29 GMT

I’ve noticed that in an unleashed network, if the master loses Ethernet connectivity it almost immediately reboots with “master became mesh”

Unfortunately at one of my networks, we heavily use MoCA and a cable modem router which reboots every few days to apply software updates. That usually doesn’t cause more than a few seconds of a disruption with SmartZone but because the Unleashed APs reboot within seconds of losing Ethernet carrier, it results in a lengthy time without wireless as Unleashed picks a new master.

Is this self healing behavior configurable?

Re: Configuring Unleashed’s auto reboot threshold?

Vineet_nejwala — Sat, 29 May 2021 05:10:54 GMT

Hi John,

As a workaround you can configure a permanent master on the network and make sure the other AP's are only member (they never participate in election) hence if the Master goes down no election will happen keeping the member AP's to serve existing wireless.

Below article can help :

https://support.ruckuswireless.com/articles/000006295

Best Regards

Vineet

Re: Configuring Unleashed’s auto reboot threshold?

john_d — Sat, 29 May 2021 20:03:01 GMT

I will give this a try, thank you!