https://community.ruckuswireless.com/t5/Unleashed/Dish-Hopper-Joey-DHCP-Issue/m-p/4662#M267 I have an unleashed R600 deployed at a site where they recently had the latest Dish Hopper/Joey system installed. The Hopper connects wirelessly to the R600 and is able to grab an IP address. A bridging mode is enabled on the Hopper for it to share the ethernet connection with the Joeys. So basically the&nbsp;Joeys should get an IP over the Coax, via MoCA, through the Dish Network Hopper ethernet connection.<BR /><BR />However in this case the Joeys are not able to get an IP address. I played around some settings on the router and etc, but once I connected the hopper to another non-ruckus AP (netgear) on the network, the joeys were able to get an IP address.<BR />Is there a setting on the R600 that needs to be adjusted for this to work? Sun, 06 May 2018 22:45:18 GMT ajay_hathiwala 2018-05-06T22:45:18Z https://community.ruckuswireless.com/t5/Unleashed/Dish-Hopper-Joey-DHCP-Issue/m-p/4662#M267 I have an unleashed R600 deployed at a site where they recently had the latest Dish Hopper/Joey system installed. The Hopper connects wirelessly to the R600 and is able to grab an IP address. A bridging mode is enabled on the Hopper for it to share the ethernet connection with the Joeys. So basically the&nbsp;Joeys should get an IP over the Coax, via MoCA, through the Dish Network Hopper ethernet connection.<BR /><BR />However in this case the Joeys are not able to get an IP address. I played around some settings on the router and etc, but once I connected the hopper to another non-ruckus AP (netgear) on the network, the joeys were able to get an IP address.<BR />Is there a setting on the R600 that needs to be adjusted for this to work? Sun, 06 May 2018 22:45:18 GMT https://community.ruckuswireless.com/t5/Unleashed/Dish-Hopper-Joey-DHCP-Issue/m-p/4662#M267 ajay_hathiwala 2018-05-06T22:45:18Z