topic Re: Access points are not reconnecting after changing IP address to controller in Unleashed

Access points are not reconnecting after changing IP address to controller

shai_fisher — Sun, 26 Jan 2020 08:57:06 GMT

we have r310 around our facility and it was working great until we had some changes in our network,
we have changed the dhcp settings and i had to change the controller's(unlieashed ap) static ip.
after changing the static ip to the new one.
i noticed that none of the other AP had reacted to the change and one day later all of them showed up as Recover.me wifi.
i have checked each network port to see that theres network connectivity and when i connected with my laptop, i got a ip address from the new DHCP and all was running good.

i have tried making factory reset but the AP just came back to RECOVER.ME

help?

Re: Access points are not reconnecting after changing IP address to controller

sanjay_kumar — Mon, 27 Jan 2020 03:04:52 GMT

Hi Shai,

APs will broadcast recover.me SSID when the APs has no reach-ability to its getaway

If they have a reachability to gateway, then after doing a factory reset the SSID should change from recover.me to configure.me.

If the APs are still broadcasting the "Recover.Me" SSID, then login to the AP CLI, use the command "get ipaddr wan" and see the gateway information is correct.

Re: Access points are not reconnecting after changing IP address to controller

sanjay_kumar — Mon, 27 Jan 2020 03:07:00 GMT

Hi Shai,

Check out the below KB for more information.

https://support.ruckuswireless.com/articles/000008823