topic Re: How to configure Ruckus R610 after LACP in Unleashed

How to configure Ruckus R610 after LACP

quoc_viet_tran — Thu, 07 Jan 2021 09:01:12 GMT

Currently, the controller and AP web UIs do not expose LACP settings or configuration. If an AP is configured via AP CLI to bond its Ethernet ports, then any per-Ethernet port setting in the web UIs are ignored by the AP.

So, how can configure Ruckus R610 after Configure LACP ?

Re: How to configure Ruckus R610 after LACP

sunny_gupta — Thu, 07 Jan 2021 14:01:11 GMT

Hello there, this must be configured via CLI. Here are the commands.

CLI Config commands

Log in to AP CLI using SSH
- Bond command on the CLI can be used to configure LACP.

Command format as below.

get bond - Show Bond Info
set bond {options} - Configure Bond/LACP settings
** <profile>: bond0, ...
** options: enable : R720 Only to enable LACP Mode
disable : R720 Only to disable LACP Mode
lacp-rate [0,1], 0 for slow, 1 for fast
xmit-hash [0,1,2], 0 for L(ayer2), 1 for L3+4, 2 for L2+3
{add|delete} <eth0| eth1>

Example:
Set bond bond0 add eth0
set bond bond0 add eth1

Get bond

Please see KB for more details:

https://support.ruckuswireless.com/articles/000009914

Re: How to configure Ruckus R610 after LACP

quoc_viet_tran — Thu, 07 Jan 2021 14:21:19 GMT

@sandeep_gupta_89lya7d7doyxy

Hi, after add eth0, eth1 to bond 0, I can't config throuh WebUI. How can I config my AP after configured LACP ?

Thanks

Re: How to configure Ruckus R610 after LACP

sunny_gupta — Fri, 08 Jan 2021 20:12:05 GMT

Hello, I'm not sure I understand.

LACP configuration is via CLI only, you cannot see or make changes from GUI. What change are you trying to make after enabling LACP?

Also I just tried this and you simply need to run the command:

set bond bond0 enable

get bond --> to confirm the status