topic Re: LACP with R610 in Unleashed

LACP with R610

salvador_gallo — Fri, 28 Sep 2018 04:27:11 GMT

Hi, in the wireless network are 2 R610 and 8 R600, and i need to know if is possible configure LACP on R610 through of two ethernet ports? or what is the purpose of two interface ethernet?

Re: LACP with R610

abilash_pr — Fri, 28 Sep 2018 04:31:06 GMT

Hi Salvador,

In R610 you can use LACP and combine two gigports.

Regards,
Abilash PR.

Re: LACP with R610

salvador_gallo — Fri, 28 Sep 2018 04:34:33 GMT

Hi Abi,

i has been research about of procedure. i found this instructions for CLI

##
To configure the AP for link aggregation:
    1. Verify that the AP power mode is 802.3at:
content_copy zoom_out_map
rkscli: get power-mode
PoE Configured Mode      : Auto
Power Consumption Status : 802.3at PoE+
OK
    2. Create the bond0 profile for the LAG group and add the two physical Ethernet interfaces to the LAG.
content_copy zoom_out_map
rkscli: set bond bond0 add eth0
rkscli: set bond bond0 add eth1

When you create the LAG group, LACP is automatically enabled.
    3. (Optional) Set the transmit hashing option to Layer 3 and Layer 4 to optimize hashing for common enterprise WLAN environments.
content_copy zoom_out_map
rkscli: set bond bond0 xmit-hash 1
###

this is corrrect?

Re: LACP with R610

abilash_pr — Fri, 28 Sep 2018 04:40:48 GMT

Hi Salvador,

Yes, that should be it.

Regards,
Abilash PR.

Re: LACP with R610

lucas_van_renne — Tue, 10 Nov 2020 18:03:56 GMT

@abi is it also possible with the r510? It also has dual ports.