topic Re: How to use the packet-capture command in ICX Switches

How to use the packet-capture command

vencolin6 — Fri, 05 Jun 2026 03:15:17 GMT

Hi everyone,

I'm trying to use the packet-capture remote command on an ICX 7550 switch, but every time I enable it, I receive the following message:

Please configure remote IP address before enabling remote packet capture

I've searched through the CLI help, configuration guides, and various documentation, but I haven't been able to find where the remote IP address is supposed to be configured.

Re: How to use the packet-capture command

MariaC862 — Sun, 14 Jun 2026 17:49:39 GMT

Hi!

Thank you for posting,

The remote packet capture feature is intended for internal support/engineering use only, that's why you won't find detailed steps on the monitoring or command guides.

May I know what is the goal here? I can provide other methods to collect and monitor traffic that align better.

Re: How to use the packet-capture command

va10462 — Tue, 23 Jun 2026 03:01:56 GMT

Hi Vencolin6,

Are you trying to mirror the port, if so you can use below configuration.

1/1/3 - pc connected port

1/1/2 - src port

First configure mirror port - pc connected port

Go to src port and configure the monitor port as pc connected port

If you are trying to capture cpu punting packets then you can use below commands

8.x code

debug packet-capture filter none

debug packet-capture mode brief

debug packet-capture max 250

show cpu

8095, 9010, 10010 code

Debug dest ssh x << 8095

- Dm raw mode brief

- Dm raw filter none

- Dm raw max 100

- Dm raw all

-Dm raw

Thanks,

Vivek