topic Re: Help needed to configure NTP client mode in ICX7150-C12 in ICX Switches

Re: Help needed to configure NTP client mode in ICX7150-C12

timothy_harryma — Tue, 29 Oct 2024 00:57:21 GMT

Hello. I also cannot get an ICX-7150 to sync with the time server.

This is my configuration:

SSH@xxx#sh run Current configuration: ! ver 08.0.95nT211 ! stack unit 1 module 1 icx7150-24-port-management-module module 2 icx7150-2-copper-port-2g-module module 3 icx7150-4-sfp-plus-port-40g-module ! .... ! ntp disable serve peer 192.168.74.4 peer 192.168.74.6 peer 10.77.25.126

The clock is set to UTC, and is within 20 seconds of the actual time. When rebooting, this was the log entry:

Oct 29 00:45:48 informational NTP: The system clock is not synchronized and does not have a reference configured.

I have saved the config, and reloaded the switch. These are my association and status

SSH@xxx#sh ntp s Clock is unsynchronized, no reference clock NTP server mode is disabled, NTP client mode is enabled NTP master mode is disabled, NTP master stratum is 8 NTP is not in panic mode SSH@xxx#sh ntp a address Domain name Reference Clock st when poll Reach delay offset disp ~ 192.168.74.4 None INIT 16 - 64 0 0.00 0.000 15937. ~ 192.168.74.6 None INIT 16 - 64 0 0.00 0.000 15937. ~ 10.77.25.126 None INIT 16 - 64 0 0.00 0.000 15937. * synced, # selected, + candidate, - outlayer, x falseticker, ~ configured, **More characters in domain name

I have captures from the firewall it is directly connected to showing the ntp requests and the ntp replies, but the switch does not seem to be processing the ntp replies and setting the clock.

Any ideas?

Re: Help needed to configure NTP client mode in ICX7150-C12

Imran_ruckus — Tue, 29 Oct 2024 12:40:07 GMT

Hi @timothy_harryma
Greetings!!!

Thank you for contacting the RUCKUS Community forums.

Could you please let me know if this is a Lennar Home RUCKUS setup?

Please confirm.

Thank you again.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

Re: Help needed to configure NTP client mode in ICX7150-C12

timothy_harryma — Tue, 29 Oct 2024 15:19:32 GMT

Sorry about that, it is not. Found the thread on Google Search, now I see it is for Lenna Home.

Re: Help needed to configure NTP client mode in ICX7150-C12

Imran_ruckus — Tue, 29 Oct 2024 17:01:39 GMT

Hi @timothy_harryma

Thank you for your response and confirmation.

No problem at all. I’m assigning this case to an Enterprise Support Engineer for further assistance. They will respond to this thread as soon as they are available.

Thank you again for your patience and understanding.

Best regards,
Imran Sanadi
RUCKUS Lennar Home Community