After ICX 7150 c12p factory reset need help assigning Ip address and basically setting everything

mpyrtle — Mon, 19 Feb 2024 00:08:43 GMT

Hello. I had to reset my ICX switch to factory and now I need a walk through to set everything back up.

I am able to get to the switch via the command line with USB-C to from the switch to my laptop. I was able to create a new password after the reset but I really don’t understand or know the commands like that to assign the IP address, default gateway, and TFtp. I have download putty and TFTP but as of now I’m stuck on assigning a IP address to the TFTP on the switch.

The commands I found on the forums seems to not work when trying to assign IP address. I just need a up to date or someone to speak to help assist getting the switch not the AP back functioning from the Lennar setup please

Re: After ICX 7150 c12p factory reset need help assigning Ip address and basically setting everythin

Mayank — Mon, 19 Feb 2024 06:02:48 GMT

Hi mpyrtle,

Thank you for reaching us.

Could you please confirm us if you are from Lennar Homes.

For Lennar accounts we have a separate page where you can always feel free to reach us and post your queries.

Please refer the below link for posting your queries for Lennar.

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/bd-p/lennar

I hope this information helps you

Please feel free to leave us a message if any concerns

topic Re: After ICX 7150 c12p factory reset need help assigning Ip address and basically setting everythin in ICX Switches

After ICX 7150 c12p factory reset need help assigning Ip address and basically setting everything

Re: After ICX 7150 c12p factory reset need help assigning Ip address and basically setting everythin