topic Re: setting single interface back to default in ICX Switches

setting single interface back to default

CSSP — Wed, 30 Aug 2023 18:22:44 GMT

Hello,

Is there a Ruckus ICX equivalent to the Cisco command #default interface to set a single interface back to its default settings??

Thank you

Re: setting single interface back to default

BenBeck — Thu, 31 Aug 2023 17:22:52 GMT

This does not exist for everything, but it does exist for port level commands (whatever shows up under 'show int eth x/y/z'. You can issue something like this:

conf t

no int eth 1/2/2

Again, this will only work for things under interface configuration.

Re: setting single interface back to default

CSSP — Thu, 31 Aug 2023 17:45:18 GMT

thank you 🙂 It completely deletes the interface but it's faster than doing a bunch of no's...and then you are sure everything is gone.