topic Re: Multi-VLAN Access Port for voip/data in ICX Switches

Multi-VLAN Access Port for voip/data

secron — Sun, 09 Jul 2023 22:36:12 GMT

Hi All,

Need assistance in configuring data and voice vlan on a port.

vlan 101 - voice

vlan 102 - data

How can I configure Multi-VLAN Access Port? I'd like the phone to be on the voip vlan but assign data vlan when a pc is connected to the phone data port.

Re: Multi-VLAN Access Port for voip/data

Chandini — Mon, 10 Jul 2023 09:32:56 GMT

Hi Secron

Thank you for reaching us .

From the details shared I suppose you are looking for a daisy chain setup in regards to the end device.

Consider interface 1/1/1 which is connected to VOIP and PC then you can use the below configuration to achieve your requirement.

Device#con t
Device(config)#vlan 101
Device(config-vlan-101)#tagged e 1/1/1 // this would be for a VOIP phone
Added tagged port(s) ethe 1/1/1 to port-vlan 101.
Device(config-vlan-101)#vlan 102
Device(config-vlan-102)#untagged e 1/1/1 // this would be for a PC device
Added untagged port(s) ethe 1/1/1 to port-vlan 102.

you can also refer below guide for more details

L2 switching configuration Guide:

https://support.ruckuswireless.com/documents/3457-fastiron-08-0-95-ga-layer-2-switching-configuration-guide

I hope this helps

Thanks

Re: Multi-VLAN Access Port for voip/data

jdryan — Wed, 12 Jul 2023 14:19:18 GMT

Hi Secron,

Adding to the details shared above :
Device#con t
Device(config)#vlan 101
Device(config-vlan-101)#tagged e 1/1/1 // this would be for a VOIP phone
Added tagged port(s) ethe 1/1/1 to port-vlan 101.
Device(config-vlan-101)#vlan 102
Device(config-vlan-102)#untagged e 1/1/1 // this would be for a PC device
Added untagged port(s) ethe 1/1/1 to port-vlan 102.

Post that, on the interface :

Device(config)#int eth < port number >
Device(config-if-e1000-<port number>)# voice-vlan 101

Should help as well.

Let us know if the same helps !

Regards