topic Re: ICX 7150-C12P in router mode in ICX Switches

ICX 7150-C12P in router mode

rleschber — Thu, 27 Apr 2023 14:12:03 GMT

I am trying to get a replacement ICX 7150 switch to connect however, I believe it is in router mode instead of switch. I have read the multiple threads on how to resolve this however, I cannot telnet in. Can someone please walk me through how to resolve this? I do not have technical experience with switches and how to telnet in so please make this as simple as possible. Thank you!

Re: ICX 7150-C12P in router mode

Chandini — Thu, 27 Apr 2023 14:36:01 GMT

Hi Rleschber

Ack and Noted. Thank you for reaching out to us.

Could you please let me know if you are from Lennar Homes ?

I have attached a link below that will help you to console to the switch and access switch CLI using putty . Follow the steps in case you are facing an issue . Please upload the picture of the image to this post .

Link :

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-console-in-the-ICX-7150-12CP-Ruckus-Switch/m-p/46759

Once you have access to switch using CLI. Please help us with below command.

Switch> enable
Switch#show run | include telnet
Switch#show telnet config

If you facing any issue or seeing a error when you follow any steps in the link. Please upload the picture of the error using the below option

Also please upload the picture of front panel of the switch using the above option .

I hope the above steps help you.

Thanks

Re: ICX 7150-C12P in router mode

rleschber — Thu, 27 Apr 2023 14:49:46 GMT

Hi, I was able finally telnet into the device and it appears both the primary and secondary code is router. I do not see the switch code in either. I do have a Lennar home. How do I resolve this?