topic Re: Show running interface configuration in ICX Switches

Show running interface configuration

Ameer — Wed, 08 Feb 2023 05:04:54 GMT

Hi All,
I am new to the Ruckus ICX Switches. How do I check the configured interface? Like Cisco products, allow the user to see the interface configuration e,g "show run config int gi 1/1/1 ".
Do we have the same feature for ruckus? I would like to use the same config for another port on ruckus, but I don't know the details of the switch interface.

# show int brief

Port Link State Dupl Speed Trunk Tag Pvid Pri MAC Name

1/1/1 Up Forward Full 1G None Yes 7 0 d4bd.4f2e.c7e6

1/1/2 Up Forward Full 1G None Yes 12 0 d4bd.4f2e.c7e7

1/1/3 Up Forward Full 1G None Yes 12 0 d4bd.4f2e.c7e8

Thank you.

Re: Show running interface configuration

Jayanth — Wed, 08 Feb 2023 06:45:13 GMT

Command is : show run interface eth1/1/1

Re: Show running interface configuration

Ameer — Wed, 08 Feb 2023 07:03:43 GMT

Hi Jayanth,

Thank you for the reply, but I still can not see the details of the configured port.

Sw1#show run interface ethernet 1/1/1

interface ethernet 1/1/1

voice-vlan 6

Re: Show running interface configuration

BenBeck — Wed, 08 Feb 2023 13:29:45 GMT

Hey @Ameer

'show run int eth /x/y/z' will you show you interface-level configurations only. 'show run' is the generic command to look at everything as the port may be referenced in multiple places. Here are some others to pull more specific information:

show run vlan (also at beginning of 'show run' - gives vlan configuration)

show run authentication (if applicable - give authentication config)

*for information, but not actual config:

show interface or show interface eth x/y/z

show vlan

show vlan <num>

show vlan eth x/y/z

show vlan brief

show vlan brief eth x/y/z

show stat

show stat eth x/y/z

Hope that helps!

Re: Show running interface configuration

PastorLopez — Sat, 18 Mar 2023 21:21:53 GMT

How do I check then the configuration of the port? If you run "show run-config" it will show the ports disabled not the ones active.

There should be a way to see each individual interface configuration.

Re: Show running interface configuration

Jayanth — Mon, 20 Mar 2023 03:54:25 GMT

The command to check the running config of a particular port is

#Show run int eth1/1/X

X - Interface number

Re: Show running interface configuration

PastorLopez — Tue, 21 Mar 2023 22:39:50 GMT

Unfortunately, that command doesn't show anything. Don't know if you have a different model, but for mine (ICX7150-C12) doesn't return anything with that command.