topic Fastiron Edge X648-prem in ICX Switches

Fastiron Edge X648-prem

maslivets_jaros — Mon, 10 Dec 2018 10:33:43 GMT

Hello. There is a problem. I have a Fastiron Edge X648-prem switch (ver. 07.4.01T3e5), I want to install a 2x10G board on it, took it from a friend, but after installing the switch it is not launched, the IP4 conflict writes. I think I need another firmware. Tell me what. Thank you in advance.

Re: Fastiron Edge X648-prem

BenBeck — Mon, 10 Dec 2018 15:36:48 GMT

It looks like the linecard is IPv6 while your chassis is IPv4. I'm not sure if it is even possible anymore as the switch it end of support, but you used to be able to upgrade the chassis via "FESX648-L3U-IPV6" license. I think that would be the only way to use the IPv6 module.

Re: Fastiron Edge X648-prem

maslivets_jaros — Mon, 10 Dec 2018 17:23:31 GMT

No. 10g board taken from x448.

Re: Fastiron Edge X648-prem

BenBeck — Mon, 10 Dec 2018 17:29:45 GMT

Looking at some old lists here and they did separate X6-2XG for FESX6xx models and X4-2XG for FESX4xx models. I'm guessing that module just isn't compatible in the FESX6.

Re: Fastiron Edge X648-prem

maslivets_jaros — Mon, 10 Dec 2018 18:09:11 GMT

I agree, but my X6-2XG is set to FESX4xx and works well.. (I am sorry, I am from Ukraine and my language is not strong)

Re: Fastiron Edge X648-prem

BenBeck — Mon, 10 Dec 2018 18:39:07 GMT

Maybe trying putting the X4-2XG in the FESX4xx and the X6-2XG in the FESX6xx?

Re: Fastiron Edge X648-prem

maslivets_jaros — Mon, 10 Dec 2018 18:42:23 GMT

No possible