https://community.ruckuswireless.com/t5/ICX-Switches/Jumbo-frame-support/m-p/12126#M175 I'm trying to figure out how to have different MTU's defined on a 7150 or 6450 switch.<BR /><BR />I've read that I have to enable Jumbo frames on the general configuration label and then restart the switch to enable the support.<BR /><BR />It appears that the MTU should be configurable per interface, however, the ip mtu commands seem to be missing when in an interface (e.g. eth 1/1/1) on a 7150.<BR /><BR />I'm guessing I'm missing something... Mon, 02 Jul 2018 15:45:18 GMT scott_farrand_f 2018-07-02T15:45:18Z https://community.ruckuswireless.com/t5/ICX-Switches/Jumbo-frame-support/m-p/12126#M175 I'm trying to figure out how to have different MTU's defined on a 7150 or 6450 switch.<BR /><BR />I've read that I have to enable Jumbo frames on the general configuration label and then restart the switch to enable the support.<BR /><BR />It appears that the MTU should be configurable per interface, however, the ip mtu commands seem to be missing when in an interface (e.g. eth 1/1/1) on a 7150.<BR /><BR />I'm guessing I'm missing something... Mon, 02 Jul 2018 15:45:18 GMT https://community.ruckuswireless.com/t5/ICX-Switches/Jumbo-frame-support/m-p/12126#M175 scott_farrand_f 2018-07-02T15:45:18Z https://community.ruckuswireless.com/t5/ICX-Switches/Jumbo-frame-support/m-p/12127#M176 Apparently the interface IP MTU is only available on the routing image. Tue, 03 Jul 2018 15:50:49 GMT https://community.ruckuswireless.com/t5/ICX-Switches/Jumbo-frame-support/m-p/12127#M176 scott_farrand_f 2018-07-03T15:50:49Z